STAMPA SU PELLICOLA PER FINESTRE

To properly apply a window film, follow these steps:1. **Clean the Window Thoroughly**: Use a glass cleaner and a lint-free cloth or razor scraper to remove all dirt, dust, and grease. Any debris can cause bubbles or prevent the film from adhering properly.2. **Measure and Cut the Film**: Measure the window dimensions and cut the film slightly larger than the window. You can trim the excess after application.3. **Prepare a Soapy Water Solution**: Mix a few drops of baby shampoo or dish soap with water in a spray bottle. This solution helps position the film and prevents it from sticking immediately.4. **Wet the Window Surface**: Spray the soapy water generously on the window. The surface should be completely wet to allow the film to slide into place.5. **Remove the Film Backing**: Carefully peel off the backing from the film. As you peel, spray the adhesive side with the soapy water to prevent it from sticking prematurely.6. **Apply the Film to the Window**: Place the wet adhesive side of the film onto the wet window. Adjust the position as needed.7. **Smooth Out the Film**: Use a squeegee or a credit card wrapped in a soft cloth to press the film onto the glass. Start from the center and work outward to remove air bubbles and excess water.8. **Trim the Edges**: Use a sharp utility knife and a straight edge to trim the film to fit the window exactly.9. **Final Squeegee Pass**: Go over the film again with the squeegee to ensure all bubbles and water are removed.10. **Let It Cure**: Allow the film to dry and cure for a few days. Avoid touching or cleaning it during this time.Tips:- Work in a dust-free environment.- Avoid applying film in direct sunlight or on hot glass.- Be patient and take your time for best results.